-Max # LEDs -28 LEDs typical (or combined LED voltage not exceeding 24.5V)
-Type of driver - Bucking Linear
-Max Current - 1000ma. X 4
-Max Voltage input - 25.0Vdc
-Max Voltage output - 24.6Vdc
-Minimum Voltage input - 13.0Vdc
-Minimum Voltage output - 12.5Vdc
-Maximum Efficiency - 96%
-PCB - Extra heavy duty 2 oz copper
-Lifespan - Every component that the driver is built with is rated for a minimum of 200,000 hours, or 23.5 years of continuous usage 24 hours per day.
-To Obtain Max Efficiency - You must use an adjustable voltage power supply to obtain maximum efficiency and to guarantee that the driver is outputting the specified current rating.
-Thermal Protection - YES, unit will power down if temp rises to 150°C
-Wire size - Use 22 gauge wire only for power input. Use a minimum of 24 gauge solid core wire to attach LEDs
-Dimming - YES, it comes with 2X FREE remotely mountable dimmer knobs!
-Available versions- 350ma, 700ma, 1000ma.
-Dimensions - 2.0in X 3.62in X 0.43in
-Thermal Dissipation- capable of dissipating over 12 watts when attached to a large heatsink* (worse case scenario when connected to a power supply with an un-ideal voltage.)
--Operating Frequency of the driver - 5 MHz! One of the fastest driver chips on the market! ZERO flickering when dimming, even when viewed with high speed cameras.
-Arduino input - YES. This is plug and play with Arduino, and even works with stock Arduino programs!
-PWM Input - YES. This accepts standard PWM for dimming and automation. Accurate linear dimming is compatible with PWM frequencies from 100 Hz to 5 kHz for PWM duty cycle down to 1%. PWM frequencies up to 50 kHz can be supported for duty cycles greater than 10%.
-Aquarium controller compatibility - YES! Any aquarium controller with 0-10V dimming can control this driver using Steve's Aquarium Controller Harness. For this driver to accept a 0-10V input, Steve's Aquarium Controller Harness is required.
- 3 year limited warranty agains manufacturing defects. Steve's LEDs, LLC will determine the nature of the defect, and your item may be repaired or replaced free of charge.
- Current version shipping is V7.0
*a heatsink is required, such as a small length of 1 -1/4" heatsink tubing, and the LED driver must interface the heatsink using a high quality thermal paste, not thermal adhesive.
The item you receive may not look identical to the picture due to continuous improvements to our products. Steve's LEDs, LLC is not responsible for accidental errors, omissions, and mistakes anywhere on this webite.